That would be very nice. Is there a ETA for this?
yes mine is stable it has been working as a 5ghz client for 4 days using @Eddiecz download 1.2 with dlna
so you mean 5ghz lient no master...is that correct
im flashing with @9000000 nitroxid firmware from 4dpa....and upgraded with @Eddiecz "lede-1.7" 5ghz master mode, wifi not showing up on the phone--change to client mode wireless not running
is there a way i could flash again from the beginning using mtd write -kernel1 and -rootfs @Eddiecz
because i tried that but the error is nvram nto found or something..or shoul i revert back to stock and flash again using @Eddiecz
you need to set your counrty code, channels available, bandwidth available. your devices may not be able to see certain channels or bandwidth.. wireless will appear down in the web interface until it is associated with a device
again thanks for the HELP sir @MR_01010100 sadly 
5g is running but my phone cant see him...maybe i think here we only have 4g/lte signal....maybe thats the cause...but ill try to backread.. and google for a while.....god bless sir
1 Like
Can't get repeater mode working with 1.7 firmware. Installed successfully relayd but it isnt working like it does on ptp52 firmware
Post detail on your setup, I will test.
Hey guys, u can use my repo based on stable lede 17.01 branch to build firmware for mir3. https://github.com/shibajee/openwrt/tree/lede-mir3 just check the commit msg for instructions.
1 Like
Good work. How about dropping packets with older kernel. Do you see any messages in syslog?
Maitenance release LEDE 1.7.1 is out. Download
It is not recommended to use older firmware versions due to bugs.
Probably within 2 weeks.
1 Like
nope, didn't face any packet loss
ifconfig eth0.2
eth0.2 Link encap:Ethernet HWaddr
inet addr:192.168.0.100 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::2a6c:7ff:fe98:6f94/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:1160959 errors:0 dropped:0 overruns:0 frame:0
TX packets:884137 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1527352166 (1.4 GiB) TX bytes:84288585 (80.3 MiB)
does ptp52 firmware 5g works
Yes, i'm using it with only the 802.11ac AP enabled 
The 2.4Ghzis only acting as a wireless client in my configuration
hopeless
mine dont have 5g
5g
what's wring with it
What is wrong with 5G wifi? What is your config? My wifi works OK on 5G. I using 5g AP all time.. Now I tested client and it is also OK.
1 Like