Working here but I note ping times > 100ms when ~20 was typical with stock. Throughput is fine in transfer tests, maybe better than stock, so it is just a latency issue.
5Ghz radio will not go above Bitrate: 6 Mbit/s either, but 2.4Ghz is working fine.
"opkg update", "opkg install ppp-mod-pppoa" and "opkg install luci-ssl";
connected the RJ11 to the internet port;
configured a pretty much standard pppoa connection with username and password for an italian ISP (the defaults for VPI and VCI are good)...
...but it doesn't seem to connect (nothing related seems to be in the logs): just to be sure not to bash my head against this uselessly (first-time lede user here), has anyone, by any chance, tried pppoa connections with this firmware?
P.S. forgot to say that I'm trying this setup in parallel with a working router.
The archer c7 is a router only not a modem. So you can only connect ethernet cables to it (RJ45) what you can do is put your modem into 'bridge' mode and connect an ethernet cable from the LAN port of the modem to the WAN port of the router
Hi! Thank you all for the great advances you've done here. It's much appreciated. I have some questions, if you don't mind... So, I've given a look at the C7 V4 PCB images here:
I understand the external antennas are used for the 5GHz radio, yet I don't see any PCB antennas for the 2.4GHz radio, or internal antennas like in the C7 v2? Are the antennas shared between both radios in this revision?
How would you rate 2.4GHz radio range and wall penetration on this unit? I have a >5 yr old 1043ND v1.8 that I'd like to replace while of course adding 5GHz n+ac support. (The one with the buggy radio, as much magic *wrt/LEDE have done for this thing can't stand the ocassional wifi crash anymore)
Would you say these initial snapshots are ok for configuring this revision as a simple WDS AP+router+firewall out of the box until the next 18.x official images are out?
If Archer C7 v4 supports Qualcomm Fast Path (as my Archer C7 v2 does), the router will improve a lot concerning speed/lag... I think v4 should be supported by Fast Path, but I'm not an expert.
Current build missed some local id's (my RU version for example).
I am not familiar with Git, so please add full bunch of local id's to tplink-safeloader.c
So, my RU router don't accept current snapshot, but allows to flash dd-wrt & I searched string "Archer" in firmware file. As result: my original RU firmware has codes: special_id:00000000, special_id:52550000; current Lede snapshot 45550000&55530000&43410000. Original KR version has 4B520000.
And current DD-wrt has all list that above.
I edited tplink-safeloader.c, rebuild image. and finally flashed Lede. All this because even in recover mode router not accept firmware with wrong regional id.
These are simply ASCII codes for the country code (4B 52 = "KR", 52 55 = "RU", 43 41 = "CA", etc). I suppose one could put all the two-letter country codes into the build so that it wouldn't matter where they sell them next.